2-210 MFP Service Manual
7500-432, -632, and -832
8 Check the heat roll and pressure roll.
Remove the fuser unit assembly.
Is there contamination or cracking on the heat roll or
pressure roll?
Replace the fuser
unit assembly.
Go to step 9.
9 Check the printer engine card assembly.
Replace the printer engine card assembly.
Perform a print test.
Does the error continue?
Go to step 10. Problem solved.
10 Check the printhead for connection.
Warning: If too much force is applied to the board when
checking it, the printhead could become misaligned.
Is the component connected properly?
Replace the RIP
card assembly.
Go to “RIP card
assembly
removal” on
page 4-130.
Replace the
connection.
Step Check Yes No
To Next Page
Loading...
