Repair information 4-87
7500-432, -632, and -832
18. Slide the PC cartridge guide (C) toward the left side and disconnect the connector from the PC cartridge
sensor connector.
19. Remove the two hooks securing the transfer roll power contact (E).
20. While pressing the PC cartridge drive coupler (F), lift the front side of the PC cartridge guide assembly (C)
upward.
21. Release the harness from the clamp on the rear side of the PC cartridge guide assembly (C).
22. While pressing the PC cartridge drive coupler (F), lower the left side of the PC cartridge guide
assembly (C).
To Next Page
Loading...
