Repair information 4-93
7500-432, -632, and -832
18. Slide the PC cartridge guide (D) toward the left side, and disconnect the connector from the PC cartridge
sensor connector (E).
19. Remove the two hooks securing the transfer roll power contact (F).
20. While pressing the PC cartridge drive coupler (G), lift the front side of the PC cartridge guide (C) upward.
21. Disconnect the connector from the sensor (humidity and temperature) (H).
22. Remove the screw securing the sensor (humidity and temperature) (H) to the PC cartridge guide (C).
23. Remove the sensor (humidity and temperature) (H).
To Next Page
Loading...
