Repair information 4-177
7500-432, -632, and -832
20. Remove the harness from the rectangular opening of the side of the ADF left cover assembly.
Note: Before reinstalling the ADF left cover assembly (E), ensure that the harness is properly routed and
is not pinched.
Note: Ensure that the harnesses are properly captured by the harness guide (I).
Note: Ensure that the green ground wire (G) and the grounding plate (H) is reconnected.
Note: Ensure that the ADF left cover assembly (E) opens and closes without binding.
Note: Ensure that the spring (K) attached to the feed/pick roll assembly (L) is properly reinstalled.
To Next Page
Loading...
