4-200 MFP Service Manual
7500-432, -632, and -832
20. Remove the bearing 8 mm (I) securing the ADF registration roll assembly (H) to the front of the feed
assembly.
21. Move the ADF registration roll assembly (H) frontward and upward.
22. Remove the ADF registration roll assembly (H).
Warning: Do not touch the rubber surface of the ADF registration roll assembly (H).
Note: Before reinstalling the registration secondary drive belt (E), ensure that it is routed properly.
Note: Loosen and then retighten the two screws that set the belt tension after tension spring (C) is
attached.
Plastic
clip
I
G
C
E
F
D
Front
H
Plastic
clip
A
B
To Next Page
Loading...
