4-228 MFP Service Manual
7500-432, -632, and -832
9. Remove two E-clips with a prying tool securing the two small pulleys (F) on the rear of the frame assembly.
10. Remove the two small guides (G) and the two small pulleys (F).
11. Remove the E-clip with a prying tool securing the large guide (H) and the large pulley (I) to the frame
assembly.
12. Remove the large guide (H) and the large pulley (I).
13. Remove the tray 3 rear cables (E) from the bottom plate (J).
Note: Before re-installing:
– Ensure tray 3 rear cables (E) are not twisted or kinked.
– Route the cables properly as shown in the figure.
Replace the cables by setting the frame assembly on its side as shown in the figure.
To Next Page
Loading...
