Lexmark X862de - Page 690

4-310 MFP Service Manual
7500-432, -632, and -832
Go Back
Previous
Next
8. Disconnect the connector of the harness from the duplex motor assembly (D) to the duplex main cable
assembly.
9. Release the harness from the clamps of the duplex unit assembly.
10. Remove the two screws securing the duplex drive motor assembly (E) to the duplex unit assembly.
11. Remove the duplex drive motor assembly (E).
12. Remove the duplex drive motor duct (F) from the duplex drive motor assembly (E).
13. Remove the e-clip with a prying tool securing the duplex drive motor fan (G) to the duplex drive motor
assembly (E).
14. Remove the duplex drive motor fan (G).
Clamps
D
Connector
G
Mark
E-Ring
Screws
F
E
Left