Functions Not Available by Internet Fax Reception
This section tells you which functions are not available for Internet Fax reception.
The following functions are available for standard fax reception, but not for Internet Faxing:
• Memory Lock Reception
• SEP Code Reception
• Authorized Reception per Sender
• Reception File Print Quantity per Sender
T.37 Full Mode
This machine is T.37 full mode compatible. T.37 full mode is an international standard for Internet Fax
transmission. (ITU-T Recommendation, RFC2532)
When an Internet Fax communication is made between T.37 full mode compatible machines, the receiver
side sends the return receipt (dispatched) in response to the reception notice request attached to the sent
e-mail. This return receipt includes the receiver's reception capability information (compression type, paper
size, and resolution). When the receiver is programmed in the Address Book as the full mode destination,
the sender side automatically registers the received information in the Address Book. This allows you to
send a subsequent Internet Fax document to that receiver based on this information.
Returning a Return Receipt
When e-mail is received, if the sender requests reception notice, the receiver sends a return receipt
that includes the receiving machine's capability (compression type, paper size, and resolution).
Registering the Received Reception Confirmation Contents
When the sender receives the return receipt that includes the receiver's reception capability, the sender
checks that the final recipient address sent is programmed in the Address Book. If it is programmed
as a full mode destination, the sender automatically registers the receiver's reception capability. The
registered reception capability is updated each time the sender receives new reception capability
information. The sender can send documents to the receiver based on this information.
If the receiver is programmed as the simple mode machine or not programmed in the Address Book,
the receiver's reception capability cannot be registered.
If you know the receiver's reception capability, you can set it manually.
Requesting a Reception Notice
When the receiver's machine supports T.37 full mode and is programmed as a full mode machine in
the Address Book, the machine requests the reception notice from the receiver. Then, the machine will
receive the return receipt (sent) that includes the receiver's reception capability.
• For details about requesting reception notice from this machine, see “Requesting a Reception Notice”.
1. Transmission
38
To Next Page
Loading...
Need help?
General