Maintaining Your Machine
If the exposure glass or ADF belt is dirty, copy clarity may be reduced. Clean these parts if they are dirty.
• Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get
inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
How to maintain
Wipe the machine with a soft, damp cloth, and then wipe it with a dry cloth to remove the water.
Cleaning the Exposure Glass
This section describes how to clean the exposure glass and the scanning glass.
To Next Page
Loading...
Need help?
General