Changing the Paper Size
This section describes how to change the paper size.
• If you want to change the paper size set in tray 3 (LCT) or large capacity tray (LCT), contact your
service representative.
• Be sure to select the paper size with User Tools. If you do not, misfeeds might occur. For details about
Tray Paper Size, see “System Settings”, General Settings Guide.
• Fan the paper before loading.
• Straighten curled or warped paper before loading.
• For details about paper sizes and types, see “Recommended Paper Sizes and Types”, About This
Machine.
Changing the Paper Size in the Paper Trays
This section describes how to change the paper size in the paper trays.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Do not stack paper over the limit mark.
• Check the paper edges are aligned with the right side.
• Slide the side fences until they are aligned with the paper size, and then re-lock the side fences.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
To Next Page
Loading...
Need help?
General