• Guideline for split
• You can adjust the overprinting and reduction lengths within the following ranges:
• Overprinting length: 4 mm (0.16 inch), 10 mm (0.39 inch), 15 mm (0.59 inch)
• Guideline for split: 5-155 mm (5 mm steps)/0.2-6.1 inches (0.2 inch steps)
Page Reduction
If you receive a document that is longer than the paper in the tray, the machine usually prints it on two
pages. If you turn this function on, the machine reduces the width and length of the received image so that
it will fit on one page.
If A4 paper is loaded and a document of B4 JIS size is received, the machine will reduce the document
to a single A4 sheet.
• You can turn this function on or off with the User Parameter (switch 10, bit 3) in the Facsimile Features
menu. See “Facsimile Features”, General Settings Guide.
• When this function is used, the printing quality may not be as good as usual.
• To split a document into two sheets without using this function, see “Page Separation and Length
Reduction”.
• p.203 "Page Separation and Length Reduction"
TSI Print (Transmitting Subscriber Identification Print)
You can have the sender's Own Name or Own Fax Number printed on documents that this machine
receives.
Usually the sender's Fax Header is printed on received documents. When you receive an Internet Fax
document, the e-mail address of the sender is printed. If the sender has not programmed their Fax Header,
3. Reception
204