• You can set the machine to enter Memory Transmission mode or Immediate Transmission mode right
after the power is turned on or whenever the [Clear Modes] key is pressed. See “Setting Transmission
Function Defaults”.
• p.25 "Parallel Memory Transmission"
• p.26 "Broadcasting sequence"
• p.152 "Setting Transmission Function Defaults"
Selecting Type of Transmission
You can select the transmission type: standard fax, IP-Fax, Internet Fax, e-mail transmission, or folder
transmission.
Press the tab in the standby display to select the transmission type.
When sending to a standard fax or IP-Fax destination
Make sure that [Fax] is selected.
When sending to an Internet Fax destination
Press [Internet Fax] to switch the type of transmission to Internet Fax.
1. Transmission
20
To Next Page
Loading...
Need help?
General