• This stamp indicates that the original has been successfully stored in memory for Memory Transmission,
or successfully sent by Immediate Transmission.
• When the stamp starts getting lighter, replace the cartridge. For details, see “Replacing the Stamp
Cartridge”, Troubleshooting.
• If a multi-page feed or paper jam occurs, the originals are not sent properly and not stamped. If you
find a page that is not stamped, send only that page again.
• You can have the machine select the Stamp function right after the power is turned on or whenever
the [Clear Modes] key is pressed. See “Setting Transmission Function Defaults”.
• You can program one of the Quick Operation keys with operations for this function. Using the Quick
Operation key allows you to omit steps 2 and 4. For details about Quick Operation Key, see “Facsimile
Features”, General Settings Guide.
• A paper jam during Parallel Memory Transmission may cause the transmission to fail even if stamping
is performed.
• You cannot turn the Stamp function on or off while an original is being scanned.
• p.152 "Setting Transmission Function Defaults"
Checking the Content of a Scanned Original (Preview Before Transmission)
The Preview Before Transmission function allows you to check the content of a scanned original before you
send it.
• To use this function, the optional HDD unit is required.
• This function cannot be used with the following functions:
• Immediate Transmission
• Parallel Memory Transmission
• On Hook Dial
• Manual Dial
• SEP Code Reception
• When [Store Only] is set for [Store File]
• Transmission of a stored file only
1. Place the original, and then specify the scan settings you require.
Specify the “Original Orientation” setting correctly. If you do not, the top/bottom orientation of the
original will not be displayed correctly in the preview.
1. Transmission
56
To Next Page
Loading...
Need help?
General