3. Enter the fax number again, and then press [OK].
The destination is specified.
4. Press the [Start] key.
Transmission starts.
After transmission, the standby display appears.
• If the "Entered destination is not correct." message appears, press [Exit] and check the fax number
again, and then repeat the procedure from step 1.
• You can specify the number of times (1 to 15) that the fax number must be re-entered. Step 3 must be
repeated as many times as is set here.
• You cannot edit the first fax number that is entered.
• You cannot use this function from the simplified display.
Sending by IP-Fax
This section explains how to specify a destination using IP-Fax transmission.
When using IP-Fax transmission, specify the IP-Fax destination (IP address, host name, or alias telephone
number) in place of the fax number.
Specifying a Destination
81