• Specify the protocol to be used in [Select Line] in advance. For details about selecting a protocol, see
“Changing the Line Port”.
1. Make sure that [Fax] is selected.
2. Press [Manual Entry].
3. Enter the IP-Fax destination, and then press [OK].
If you enter an incorrect character, press [ ], [ ], [Backspace], or [Delete All]. Then, re-enter the
characters correctly.
To change the IP-Fax destination after pressing [OK], press [Edit Dest.], re-enter an IP-Fax destination,
and then press [OK].
4. To add a destination, press [Add].
1. Transmission
82
To Next Page
Loading...
