When You Cannot Make Clear Copies
This section describes likely causes of and possible solutions for unclear copies.
Problem Cause Solution
Copies appear dirty. Image density is too high. Adjust the image density settings. See
“Adjusting Copy Image Density”,
Copy/Document Server Reference.
Copies appear dirty. Auto Image Density is not
selected.
On the control panel, select [Auto
Density].
The reverse side of an original
image is copied.
Image density is too high. Adjust the image density settings. See
“Adjusting Copy Image Density”,
Copy/Document Server Reference.
The reverse side of an original
image is copied.
Auto Image Density is not
selected.
On the control panel, select [Auto
Density].
A shadow appears on copies
if you use pasted originals.
Image density is too high. • Adjust the image density settings.
See “Adjusting Copy Image
Density”, Copy/Document Server
Reference.
• Change the orientation of the
original.
• Put mending tape on the pasted
part.
The same copy area is dirty
whenever making copies.
The exposure glass, scanning
glass, or ADF is dirty.
Clean them. See p.137 "Maintaining
Your Machine".
The same copy area is dirty
whenever making copies.
• The original that has
already been printed is
scanned.
• Original Type is set to
[Text / Photo], and an
original with text and
photographs that can
hardly be distinguished
from each other is
loaded.
On the control panel, press [Generation
Copy], and then begin copying.
2. Troubleshooting When Using the Copy/Document Server Function
24
To Next Page
Loading...
