Form Feed
This section gives instructions for operating the machine when there is no tray for the selected paper size
or type, or when paper loaded in the machine has run out.
• The tray cannot be changed if the following functions are set:
• Staple
• Punch
• Duplex Print to a tray that does not support duplex printing
• Cover Sheet
• Front and Back Cover Sheet
• Slip Sheet
• Chaptering
• Chapter Slip Sheets
• If form feed is selected for a tray with the following settings, you can change the tray by canceling
the settings:
• Staple
• Punch
• Duplex
• If Auto Continue is selected, form fed paper is printed after a set interval. See "Printer Features",
General Settings Guide.
Printing from a Selected Tray
If the machine does not have a tray for the selected paper size or paper type, or if the selected paper
loaded in the machine has run out, a caution message appears. If this message appears, do the following
procedure.
1. Press the [Printer] key.
2. Select the tray for form feed from those that appear on the control panel.
If you want to print after adding paper to the tray, select the tray after loading the correct paper.
3. Press [Continue].
The machine prints using the selected tray.
Form Feed
107
To Next Page
Loading...
