Messages Displayed When Using the Printer
Function
This section describes the principal messages that appear on the panel display. If a message not described
here appears, act according to the message.
Status Messages
This section describes the machine status messages.
Message Status
"Hex Dump Mode" In the Hex Dump mode, the machine receives data in
hexadecimal format. Turn off the machine after printing, and
then turn back on.
"Job Suspended..." All jobs in the machine are suspended. Wait a while.
"Offline" The machine is offline. To start printing, switch the machine
online by pressing [Online].
"Please wait." This message might appear for a second or two while the
machine is preparing, performing initial adjustments, or
adding toner. Wait a while.
"Ready" This is the default ready message. The machine is ready for
use. No action is required.
"Resetting job..." The machine is resetting the print job. Wait until "Ready"
appears on the display panel.
"Setting change..." The machine is setting changing. You cannot use the control
panel while this message is displayed. Wait a while.
"Waiting..." The machine is waiting for the next data to print. Wait a while.
Messages Displayed on the Control Panel When Using the Printer Function
This section describes likely causes of and possible solutions for the error messages that appear on the
control panel.
• Before turning the main power off, see “Turning On/Off the Power”, About This Machine.
Messages Displayed When Using the Printer Function
59
To Next Page
Loading...
