Scanning Multiple Pages of Originals as One File
This section explains the procedure for sending multiple originals as a multi-page file or storing them as a
single stored file.
• To send multiple originals as a multi-page file, in [Send File Type / Name], select a multi-page file
type. For details about file types, see "Specifying the File Type".
1. Press [Original Feed Type].
2. Select [Batch] or [SADF].
To scan originals using the exposure glass, select [Batch]. To scan originals using the ADF, select
[SADF]. For detail about [Batch] and [SADF], see "Batch, SADF".
3. Press [OK].
4. Place originals.
5. Make settings for sending by e-mail or Scan to Folder, delivering, or storing.
6. Press the [Start] key to scan originals.
If [Batch] is selected, place additional originals, and then press the [Start] key.
If [SADF] is selected, scanning starts automatically when you place additional originals.
Repeat this step until all originals are scanned.
7. After all originals are scanned, press the [ ] key.
Storing or transmission starts.
• If [Batch] is selected, originals can be scanned using the ADF.
• When scanning originals using the exposure glass, depending on the settings for [Wait Time for
Next Orig.: Exposure Glass] under [Scanner Features], the machine can wait for additional
originals even if [Batch] is not selected in [Original Feed Type]. For details about [Wait Time for
Next Orig.: Exposure Glass], see "Scanner Features", General Settings Guide.
Scanning Multiple Pages of Originals as One File
139
To Next Page
Loading...
