• p.41 "Sending to E-mail/Folder Destinations"
Memory Transmission
Memory Transmission mode has standard fax, Internet Fax, IP-Fax, e-mail transmission, and folder
transmission.
• If there is a power failure (the main power switch is turned off) or the machine is unplugged for about
one hour, all the documents stored in memory are deleted. As soon as the main power switch is turned
on, the Power Failure Report is printed to help you check the list of deleted files. Simply turning off the
power by pressing the operation switch does not delete stored documents. See “Turning Off the Main
Power / In the Event of Power Failure”, Troubleshooting.
• If memory is full (0% appears in “Memory” at the upper right of the screen), Memory Transmission is
disabled. Use Immediate Transmission instead.
1. Make sure [Immed. TX] is not highlighted.
Normally Memory Transmission mode is selected.
2. Place the original into the ADF.
3. Make the scan settings you require.
For details about the scan settings, see “Scan Settings”.
1. Transmission
22
To Next Page
Loading...
Need help?
General