Acceptable Original Sizes
This section describes the size and thickness limitations that apply to originals placed on the exposure glass
or the ADF.
Where original is set Acceptable original size
Maximum number
of sheets
Paper
thickness
Exposure glass Up to A3 (297 × 420 mm),
11 × 17 (279 × 432 mm)
1 sheet
ADF, one-sided
original
B6 JIS to A3 (up to 1200 mm long)
5
1
/
2
× 8
1
/
2
to 11 × 17
100 sheets
(80 g/m
2
, 20 lb)
40-128 g/m
2
(11-34 lb)
ADF, two-sided
original
A5 to A3 (up to 432 mm long)
5
1
/
2
× 8
1
/
2
to 11 × 17
100 sheets
(80 g/m
2
, 20 lb)
52-128 g/m
2
(14-34 lb)
• The weight range for originals in the Mixed Original Sizes mode is 52-81.4 g/m
2
, 13.8-21.5 lb.
Paper Size and Scanned Area
This section explains the size of the area the machine can scan and detect.
• There may be a difference in the size of the image when it is printed at the destination.
• Even if an original is correctly placed on the exposure glass or in the ADF, a margin of 3 mm (0.1
inch) around each edge of the original may not be sent.
• If the receiver uses paper of a smaller width than the original, the image is reduced to fit that paper.
See “Auto Reduce”.
• p.169 "Auto Reduce"
When placing an original on the exposure glass
This section explains how to place an original on the exposure glass.
• If you place an original larger than A3, 11 × 17 on the exposure glass, only an A3, 11 × 17 area
is scanned.
1. Transmission
50
To Next Page
Loading...
Need help?
General