2. Remove the originals that were being copied.
3. Place the originals you want to copy.
4. Press the [Start] key.
The machine starts making copies.
5. When copying is complete, remove the originals and copies.
6. Press the [Interrupt] key again.
The interrupt key indicator goes off.
7. Replace the originals that you were copying, and then press the [Start] key.
Following the instructions on the display.
• The previous copy job settings are restored. Simply press the [Start] key to continue copying from
where it left off.
Job Preset
You can make settings for the next copy job during copying.
If a long copy job is in progress and you do not want to wait for it to finish, you can use this function to set
up the next copy job in advance. When the current copy job is finished, the next job will start automatically.
1. Press [New Job] when "Copying..." appears.
Basic Procedure
35
To Next Page
Loading...
