Ricoh C231 - Service Program Mode Access Procedure (for Users); Service Program Table

ACCESS PROCEDURE
4-9
SM C231/C237/C238
Service
Tables
3. Using the
number keys
, enter the desired SP mode number (listed in the
service program table), then press the
Enter (#) key
.
NOTE:
The SP mode number can be shifted up or down by pressing the
Select Size And Direction ("
∧" or "∨") keys.
4. Follow the "Change Adjustment Values or Modes" procedure on page 4-10.
NOTE:
To cancel SP mode, press the Clear Modes key. To shift to another
SP mode number, press the Enter (#) key again to return to the display
in step 2. Enter the desired SP mode number.
After you enter SP mode with Method 3, you can leave it by turning the
main switch off then on again.
Service Program Mode Access Procedure (For Users)
This procedure allows users to access only the service program modes that are
marked with an asterisk in the service program table.
1. Press the following keys on the operation panel in the following order:
- Method 1 -
Clear Modes ⇒ Clear/Stop
*: Hold down the Clear/Stop key for more than 3 seconds.
- Method 2 -
Clear Modes ⇒ Clear/Stop ⇒ Enter (#)
2. The following is displayed on the LCD.
3. Using the number keys, enter the desired SP mode number (listed in the
service program table), then press the Enter (#) key.
4. Do the following procedure (‘Change Adjustment Values or Modes’). To cancel
the SP mode, press the Clear Modes key.
SP-MODE
PROGRAM No. 0