PICK-UP AND SEPARATION
C600 8-8 SM
2.2 PICK-UP AND SEPARATION
When the print key is pressed, the DF pick-up solenoid [A] turns on and the
entrance guide [B] lifts up the originals to the pick-up roller [C]. At the same time,
the DF feed clutch [D] turns on.
200 ms after this, the DF transport motor [E] turns on. The original is fed to the
paper feed belt [F] from the top page. The pages are separated by the separation
roller [G] and the top sheet of the original is fed to the 1st transport roller [H]. The
original separation system uses an FRR system.
C600D105.WMF
C600D106.WMF
[C]
[A]
[B]
[G]
[H]
[F]
[D]
[E]
To Next Page
Loading...
