Ricoh C231 - Feed Belt Replacement; Pick-Up Roller Replacement

PICK-UP ROLLER REPLACEMENT
C600 8-12 SM
3.3 PICK-UP ROLLER REPLACEMENT
1. Remove the feed unit.
2. Remove the snap ring [A].
3. Replace the pick-up roller [B].
3.4 FEED BELT REPLACEMENT
1. Remove the feed unit.
2. Remove the E-ring [A], bearing [B], washers [C], and spring [D].
3. Remove the E-ring [E], and remove the original guide [F].
4. Release the idle roller holder [G] from the drive roller shaft [H], then release the
idle roller.
5. Replace the feed belt [I].
C600R103.WMF
C600R104.WMF
[A]
[I]
[H]
[B]
[A]
[B]
[D]
[F]
[E]
[C]
[G]