Ricoh C231 - Switches

SERVICE PROGRAM TABLE
4-17
SM C231/C237/C238
Service
Tables
No. Display Function Settings
Factory
Setting
Comments
*120
-1
User Code
Mode
Selects user code mode. 0: No
1: Yes
See the user
code mode
section.
-2
Auto Reset
Time
Selects the auto reset time.
0: Unlimited
1: 1 min.
2: 2 min.
3: 3 min.
4: 4 min.
5: 5 min.
0
Displays only
when "Yes" is
selected in
SP120-1.
*121 UC Count
Displays the total number of
masters and prints made
with each user code.
0
Press the # key
to shift to
another user
code.
*122 Clear UC
Count
Clears the selected user
code counter.
0: No
1: Yes
0 Same as
above.
*123 Total UC
Count
Displays the total number of
masters and prints for up to
20 user codes.
0
*124 Clear Total
UC Count
Clears the total user code
counter.
0: No
1: Yes
0
130
Input Check
Mode
Displays the inputs from
sensors and switches.
See the input
check table.
131 Output
Check Mode
Turns on the electrical
components.
See the output
check table.
132 All Indicators
ON
Turns on all the indicators
on the operation panel.
Press the # key
to light all the
indicators.
135 SN: Master
End
Displays the master end
sensor voltage.
Unit: Volts
140 Ink Detection
Specifies whether ink
detection is done.
0: No
1: Yes
1
141 Paper
Detection
Specifies whether paper
end detection is done.
0: No
1: Yes
1
142 Master End
Detection
Specifies whether master
end detection is done.
0: No
1: Yes
1
146
ADF Cover
Detection
This mode disables the ADF
cover switch.
0: No
1: Yes
1
This function is
valid only when
SP2 is set at
"1".
147 ADF Set
Detection
This mode disables the
platen cover sensor
detection.
0: No
1: Yes
1 If "0" is
selected, "Set
the original" is
displayed each
time at master
making.
150 Control ROM
No.
Displays the ROM part
number and the ROM
manufacturing date.
P/No. YYYY/MM/DD