PCRIP-EZ1
USER’S
GUIDE
User's Guide 8-17 PCRIP-EZ1
3. QuickDraw Printing on the Macintosh
NOTE:
The DigiPrint Utility program and associated files should have already been copied from this utility
disk to a location on the hard disk that can be easily accessed.
Customized Driver Installation for the Macintosh:
A. Insert the Macintosh Utility disk in the floppy drive.
B. Double-click on the floppy disk icon to it.
C. Drag the
DigiPrint
file icon and drop in the Extensions Folder inside the System Folder on your hard
disk.
D. Drag the
DigiPrint Prefs
folder and drop it in the Preferences Folder inside the System Folder.
E. Drag the
DigiPrint Monitor
icon and drop it in a location that is easily accessible. (We recommend
creating a folder on the hard disk named “DigiPrint Monitor” to contain this program so it can be found
quickly.)
To print:
A. Using the pull-down menu from the Apple icon, point and click on Chooser.
B. Within the Chooser left-hand dialog box, point and click on the
DigiPrint
icon.
C. The Macintosh will poll the AppleTalk printer network and return the
Priport
name (or the personalized
name if you renamed the printer as described earlier).
D. Click on
Setup
to bring up the Model Selection screen.
E. Click and hold the mouse button on the down arrow to the right of the “Model file” dialog box to see a
menu of Priport model selections. Highlight the appropriate Priport model and release the mouse button
to select it.
F.
The Priport model file you just selected should be displayed in the dialog box. If the Priport model is
not correct, repeat the step above.
G. Click
OK
to close the Model Selection screen.
When you close the Chooser, the Macintosh is ready to send print files to the Controller from any
Macintosh software program. The DigiPrint driver together with the model file selected in the Chooser
will support all possible output page sizes at the correct resolution for that Priport model.
To Next Page
Loading...
