SP TABLE (SP 5-XXX)
C267 5-10 SM
5.6 OUTPUT MODE
5.6.1 SP TABLE (SP 5-XXX)
No. Menu Items No. Menu Items
1 Exposure lamp (xenon lamp) 60 ADF motor
2 Scanner motor - scan 61 ADF feed clutch
3 Scanner motor - return 62 ADF pick-up solenoid
4 Scanner to HP 63 Key counter signal
8 Master feed motor – Forward 64 Not used
9 Cutter motor – to HP 65 Key card (Japan only)
10 Cutter motor – reverse
11 Cutter motor – forward 90 Main motor – to HP
12 VHD signal 91 Main motor – to Master clamp
13 Master eject motor
14 Pressure plate motor - limit 100 All indicators on the panel
15 Pressure plate motor -to HP
111 Auto Off solenoid
17 Main motor - 30 rpm
18 Main motor - 60 rpm
19 Main motor - 80 rpm
20 Main motor - 100 rpm
21 Main motor - 130 rpm
23 Clamper motor: to open
24 Clamper motor: to close
25 Ink pump motor
26 Pressure release solenoids
30 Table motor – down
31 Table motor – up
35 Paper feed clutch
40 Registration motor - 30 rpm
41 Registration motor - 60 rpm
42 Registration motor - 80 rpm
43 Registration motor - 100 rpm
44 Registration motor - 130 rpm
46 Air knife fan motors
47 Vacuum fan motor
48 PSU fan motor
50 Paper counter
51 Master counter
To Next Page
Loading...
Need help?
General
