ACCESSING SP MODES
SM 5-1 C267
C267 Service
Manual
5. SERVICE PROGRAM MODE
NOTE: The Service Program Mode is for use by service representatives only so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.
5.1 USING SERVICE PROGRAM MODES
Use the service program modes (SP modes) to check electrical data, change
operating modes, and adjust values.
5.1.1 ACCESSING SP MODES
Entering SP Mode
1. Key in the following sequence.
" → → → → D
• Hold the D key down for longer than 3 seconds.
Leaving SP Mode
Press the " key one or more times.
To Next Page
Loading...
