Ricoh C231 - Page 302

INPUT/OUTPUT CHECK MODE
C231/C237/C238 4-12 SM
No. Display Function Settings
Factory
Setting
Comments
*172
ERS. **3 Enter the original size that
you want to use with the
Margin Erase mode.
(100 to
258) x (100
to 364) mm
or
(4.0 to
10.0) x (4.0
to 14.3 )
inch
0 x 0 Same as
above
4.3 INPUT/OUTPUT CHECK MODE
Input Check Table
*: Not used for the C237 model
Code LCD Display Component Checked
1
SN: ADF Cover
In- 1
ADF Cover Switch
2
SN: 1st Original
(ADF) In- 2
Document Sensor
3
SN: 2nd Original
(ADF) In- 3
Scan Line Sensor
18
SN: Paper End
In-18
Paper End Sensor
20
SN: Paper Table Low
Limit
In-20
Table Lower Limit Sensor
21
SN: Paper Height
In-21
Paper Height Sensor
22
KEY: Table Down
In-22
Paper Table Lowering Switch
26
SN: Master End
In-26
Master End Sensor
27
SIG: Ink
In-27
When the Ink Detecting Pin detects ink
31
SN: Pressure Plate
Home Position
In-31
Pressure Plate Home Position Sensor
32
SN: Pressure Plate
Limit Position
In-32
Pressure Plate Limit Sensor
33
SW: Master Eject Box
In-33
Eject Box Set Sensor
39
SIG: Key Counter
In-39
When a key counter is installed