Rohde & Schwarz R&S SMW200A - Page 1086

Remote Control Commands
R&S
®
SMW200A
1086User Manual 1175.6632.02 ─ 30
Marker Settings
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE...............................................1086
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime............................................ 1086
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime...........................................1086
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern............................................ 1086
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider.................................. 1087
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?..........................1087
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay...............................................1087
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:MODE <Mode>
Defines the signal for the selected marker output. For detailed description of the regu-
lar marker modes, refer to "Marker Modes" on page 232.
Parameters:
<Mode> RESTart | PULSe | PATTern | RATio
*RST: RESTart
Example: See "Programming Examples" on page 1071
Manual operation: See "Marker Mode" on page 257
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:ONTime <OnTime>
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:OFFTime <OffTime>
Sets the number of samples in the off period of the corresponding marker signal.
*)
If R&S SMW-B9 is installed, the minimum marker duration depends on the sample/
symbol rate.
See "Marker Minimum Duration" on page 234.
Parameters:
<OffTime> integer
Range: 1 (R&S SMW-B10) / 1* (R&S SMW-B9) to
16777215
*RST: 1
Example: see "Programming Examples" on page 1071
Manual operation: See "Marker Mode" on page 257
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PATTern <Pattern>, <BitCount>
Defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern> numeric
*RST: #H2
SOURce Subsystem