Rohde & Schwarz R&S SMW200A - Page 1154

Remote Control Commands
R&S
®
SMW200A
1154User Manual 1175.6632.02 ─ 30
// activate the LF output and select the LF1 as signal source
// configure the LF output signal
SOURce1:LFOutput1:FREQuency:MODE CW
SOURce1:LFOutput1:STATe 1
SOURce1:LFOutput1:SOURce LF1
SOURce1:LFOutput1:INTernal:VOLTage 1
SOURce1:LFOutput1:OFFSet 0.001
● LF Generator Settings.........................................................................................1154
● LF Sweep Settings.............................................................................................. 1161
14.19.11.1 LF Generator Settings
With the commands described in this section, you can configure the LF signal source.
[:SOURce]:LFOutput<ch>:BANDwidth?.......................................................................... 1154
[:SOURce<hw>]:LFOutput<ch>:FREQuency...................................................................1155
[:SOURce<hw>]:LFOutput<ch>:PERiod?........................................................................1155
[:SOURce<hw>]:LFOutput:FREQuency:MANual..............................................................1155
[:SOURce<hw>]:LFOutput:FREQuency:MODE................................................................1156
[:SOURce<hw>]:LFOutput:FREQuency:STOP.................................................................1156
[:SOURce<hw>]:LFOutput:FREQuency:STARt................................................................1156
[:SOURce]:LFOutput<ch>[:STATe]................................................................................. 1157
[:SOURce]:LFOutput<ch>:OFFSet................................................................................. 1157
[:SOURce]:LFOutput<ch>:SOURce................................................................................1157
[:SOURce]:LFOutput<ch>:SOURce:PATH.......................................................................1158
[:SOURce]:LFOutput<ch>:VOLTage............................................................................... 1158
[:SOURce<hw>]:LFOutput<ch>:SHAPe..........................................................................1158
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle.................................................. 1158
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod...................................................1159
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:WIDTh....................................................1159
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL...................................................1159
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:HIGH.................................................. 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:PERiod............................................... 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:RISE...................................................1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:PERiod................................................ 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE................................................... 1161
[:SOURce]:LFOutput<ch>:BANDwidth?
Queries the bandwidth of the external LF signal.
Return values:
<Bandwidth> BW0M2 | BW10m
*RST: BW10m
Example:
LFO:BAND?
// BW10m
// the bandwidth of the externally supplied LF signal is 10 MHz
Usage: Query only
SOURce Subsystem