Rohde & Schwarz R&S SMW200A - Page 985

Remote Control Commands
R&S
®
SMW200A
985User Manual 1175.6632.02 ─ 30
● SOURce:BB:GRAPhics Subsystem....................................................................1103
● SOURce:BB:MEASurement Subsystem............................................................. 1107
● SOURce:BB:PROGress Subsystem General Commands.................................. 1112
14.19.4.1 SOURce:BB Subsystem General Commands
The following section describes the commands for setting the frequency shift and the
phase offset for the signal at the output of the "Baseband" and "BB Input" blocks.
Suffixes in the keywords ENTity<ch> and SOURce<hw>
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
Table 14-3: Value ranges of the suffixes ENTity<ch> and SOURce<hw> in advanced configuration
with multiple entities
SCPI Syntax
ENTity<ch> SOURce<hw>
SOURce<hw>:BB:...
- 1 to 8
ENTity<ch>:SOURce<hw>:BB:...
1 to 8 1 to 4
See also Chapter 14.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 842.
The following commands are available:
[:SOURce<hw>]:BBIN:FOFFset.......................................................................................985
[:SOURce<hw>]:BB:FOFFset..........................................................................................985
[:SOURce<hw>]:BBIN:POFFset.......................................................................................986
[:SOURce<hw>]:BB:POFFset..........................................................................................986
[:SOURce<hw>]:BB:PGAin............................................................................................. 986
[:SOURce<hw>]:BBIN:PGAin.......................................................................................... 986
[:SOURce<hw>]:BB:ROUTe............................................................................................ 987
[:SOURce<hw>]:BBIN:ROUTe.........................................................................................987
[:SOURce<hw>]:BB:CODer:MODE..................................................................................987
[:SOURce<hw>]:BB:POWer:PEAK?.................................................................................987
[:SOURce<hw>]:BB:CFACtor?.........................................................................................988
[:SOURce<hw>]:BB:POWer:RMS?.................................................................................. 988
[:SOURce<hw>]:BBIN:FOFFset <FOffset>
[:SOURce<hw>]:BB:FOFFset <FOffset>
Sets a frequency offset for the internal/external baseband signal. The offset affects the
generated baseband signal.
SOURce Subsystem