Rohde & Schwarz RTP044 - Page 1812

Remote control commands
R&S
®
RTP
1812User Manual 1337.9952.02 ─ 12
BUS<m>:RFFE:CLOCk:THReshold:LOW.......................................................................1814
BUS<m>:RFFE:CLOCk:THReshold:HYSTeresis............................................................. 1814
BUS<m>:RFFE:GFILter................................................................................................1815
BUS<m>:RFFE:GFWidth.............................................................................................. 1815
BUS<m>:RFFE:MINGap:SELect................................................................................... 1815
BUS<m>:RFFE:MINGap:TIME...................................................................................... 1815
BUS<m>:RFFE:RDMD................................................................................................. 1816
BUS<m>:RFFE:VERSion..............................................................................................1816
BUS<m>:RFFE:CLOCk:SOURce <SourceClock>
Sets the source of the RFFE clock line.
For triggering on a serial bus, analog or digital input channels are required.
Suffix:
<m>
.
1..4
Parameters:
<SourceClock> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C2W1
BUS<m>:RFFE:DATA:SOURce <SourceData>
Sets the source of the RFFE data line. For triggering on a serial bus, analog or digital
input channels are required.
Suffix:
<m>
.
1..4
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C1W1
BUS<m>:RFFE:PRESet <ThresholdPreset>
Sets default threshold voltages for 1.2 V or 1.8 V bus. Set the value to MAN if you want
to define individual thresholds.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdPreset> V12 | V18 | MANual
*RST: V12
Protocols