Rohde & Schwarz RTP044 - Page 1826

Remote control commands
R&S
®
RTP
1826User Manual 1337.9952.02 ─ 12
22.17.13.3 Decode results
In all BUS<m>:RFFE commands, the suffix <m> selects the serial bus. Suffix <n>
selects index of the command sequence.
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1550
●
BUS<m>:SYMBols on page 1550
BUS<m>:RFFE:FCOunt?..............................................................................................1826
BUS<m>:RFFE:SEQuence<n>:STATe?..........................................................................1826
BUS<m>:RFFE:SEQuence<n>:STARt?..........................................................................1827
BUS<m>:RFFE:SEQuence<n>:STOP?.......................................................................... 1827
BUS<m>:RFFE:SEQuence<n>:TYPE?.......................................................................... 1827
BUS<m>:RFFE:SEQuence<n>:SADD?..........................................................................1828
BUS<m>:RFFE:SEQuence<n>:ADDRess?.....................................................................1828
BUS<m>:RFFE:SEQuence<n>:BCOunt?....................................................................... 1829
BUS<m>:RFFE:SEQuence<n>:DATA?...........................................................................1829
BUS<m>:RFFE:SEQuence<n>:SYMBol?....................................................................... 1829
BUS<m>:RFFE:SEQuence<n>:PADone?....................................................................... 1830
BUS<m>:RFFE:SEQuence<n>:PADZero?......................................................................1830
BUS<m>:RFFE:SEQuence<n>:PCTRl?......................................................................... 1830
BUS<m>:RFFE:SEQuence<n>:RBTRate?......................................................................1830
BUS<m>:RFFE:SEQuence<n>:WBTRate?.....................................................................1831
BUS<m>:RFFE:SEQuence<n>:BYTE<o>:NAME?...........................................................1831
BUS<m>:RFFE:SEQuence<n>:BYTE<o>:STATe?...........................................................1831
BUS<m>:RFFE:SEQuence<n>:BYTE<o>:VALue?.......................................................... 1832
BUS<m>:RFFE:FCOunt?
Returns the number of command sequences in the current acquisition.
Suffix:
<m>
.
1..4
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:RFFE:SEQuence<n>:STATe?
Returns the overall state of the selected command sequence.
Suffix:
<m>
.
1..4
Protocols