EasyManua.ls Logo

Rohde & Schwarz RTP044 - Page 1994

Rohde & Schwarz RTP044
2403 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
RTP
1994User Manual 1337.9952.02 ─ 12
OPXX
Any frame type
*RST: OPXX
Note that the user interface shows interpretations of the numeri-
cal OpCode values corresponding to Clause 45. Clause 22 is
not represented by this interpretation.
TRIGger<m>:MDIO:PHYS <PhyAddr>
Sets the physical address (in Clause 22) or port address (in Clause 45) of the frame
pattern (5 bits); available only in trigger type "Data".
Parameters:
<PhyAddr>
TRIGger<m>:MDIO:REGI
<RegAddr>
Sets the register address (in Clause 22) or device address (in Clause 45) of the frame
pattern (5 bits); available only in trigger type "Data".
Parameters:
<RegAddr>
TRIGger<m>:MDIO:DATA <Data>
Defines the 16-bit payload data pattern (both in Clause 22 or Clause 45) or the
address pattern (in Clause 45, only) to trigger for; available only in trigger type "Data".
Parameters:
<Data>
22.17.18.3 Decode results
In all BUS<m>:MDIO:WORD<n> commands, the suffix <m> selects the serial bus and
the suffix <n> selects the word number in the decode table.
BUS<m>:MDIO:WCOunt?.............................................................................................1995
BUS<m>:MDIO:WORD<n>:DATA?................................................................................ 1995
BUS<m>:MDIO:WORD<n>:PHYS?............................................................................... 1995
BUS<m>:MDIO:WORD<n>:REGI?................................................................................ 1995
BUS<m>:MDIO:WORD<n>:ST?.................................................................................... 1996
BUS<m>:MDIO:WORD<n>:STARt?...............................................................................1996
BUS<m>:MDIO:WORD<n>:STATe?...............................................................................1996
BUS<m>:MDIO:WORD<n>:STOP?................................................................................1997
BUS<m>:MDIO:WORD<n>:SYMBol?.............................................................................1997
BUS<m>:MDIO:WORD<n>:TYPE?................................................................................1998
Protocols

Table of Contents

Other manuals for Rohde & Schwarz RTP044

Related product manuals