Protocol analysis
R&S
®
RTP
702User Manual 1337.9952.02 ─ 12
Remote command:
BUS<m>:DPHY:DPZero:HSPeed:THReshold on page 1847
BUS<m>:DPHY:DPONe:HSPeed:THReshold on page 1847
BUS<m>:DPHY:DPTWo:HSPeed:THReshold on page 1847
BUS<m>:DPHY:DPTHree:HSPeed:THReshold on page 1847
Set thresholds
Opens a dialog to set the threshold values.
HS Hysteresis ← Set thresholds
Sets a value for the hysteresis of the respective lane.
Remote command:
BUS<m>:DPHY:CP:HSPeed:HYSTeresis on page 1847
BUS<m>:DPHY:DPZero:HSPeed:HYSTeresis on page 1847
BUS<m>:DPHY:DPONe:HSPeed:HYSTeresis on page 1847
BUS<m>:DPHY:DPTWo:HSPeed:HYSTeresis on page 1847
BUS<m>:DPHY:DPTHree:HSPeed:HYSTeresis on page 1847
Low power thresholds ← Set thresholds
Sets the thresholds for the low-power mode.
DP0 High / DN0 High ← Low power thresholds ← Set thresholds
Sets the high-power threshold value for the respective lane.
Remote command:
BUS<m>:DPHY:DNZero:LPOWer:THUPper on page 1845
BUS<m>:DPHY:DPZero:LPOWer:THUPper on page 1845
DP0 Low / DN0 Low ← Low power thresholds ← Set thresholds
Sets the low-power threshold value for the respective lane.
Remote command:
BUS<m>:DPHY:DNZero:LPOWer:THLower on page 1846
BUS<m>:DPHY:DPZero:LPOWer:THLower on page 1846
Couple thresholds ← Set thresholds
Enables coupling, i.e. the same threshold and hysteresis value is used for all lanes.
Remote command:
BUS<m>:DPHY:THCoupling on page 1845
13.13.2.2 Display settings
Access: [Protocol] > "Configuration" tab > "Protocol = D-PHY" > "Display" tab
To enhance the decode possibilities of the D-PHY protocol, you can use an additional
setting in the "Display" tab: "Decode layer".
Access: [Protocol] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 514.
D-PHY (ption R&S
RTP-K42)
To Next Page
Loading...
