Getting started
R&S
®
RTP
77User Manual 1337.9952.02 ─ 12
Run / Stop and Single
Starts and stops the continuous acquisition, or starts a defined number of acquisition
cycles. The icons have the same functionality as the corresponding keys on the front
panel. They are useful when you control the instrument remotely.
Find Level
Analyses the signal and sets the trigger level to the middle of the signal peaks.
Force Trigger
Starts an immediate single acquisition. If the acquisition is running in normal mode and
no valid trigger occurs, use "Force Trigger" to confirm that a signal is available. Then
you can use the displayed waveform to determine how to trigger on it.
Demo
Opens the "Demo" dialog, where you can find examples of operating the R&S RTP.
Zoom
The zoom icon on the toolbar shows the last selected zoom type. A short tap on the
icon activates the selected zoom.
To use another zoom type, select it in the toolbar assist.
Standard zoom ← Zoom
Displays a magnified section of the diagram in an additional zoom diagram. It is a dis-
play zoom, instrument settings are not changed.
Touch and hold the zoom area to open the "Zoom" dialog box.
Remote command:
LAYout:ZOOM:ADD on page 1319
Hardware zoom ← Zoom
Changes the instrument settings - horizontal and vertical scales as well as trigger level
and offset - to display a part of the diagram in greater detail.
Coupled zoom ← Zoom
Creates a coupled zoom area and its related zoom diagram. If you change the size of
one zoom area, the size of all coupled zoom areas is changed as well.
Remote command:
LAYout:ZOOM:ADDCoupled on page 1319
Fingertip zoom ← Zoom
Magnifies the waveforms around your fingertip.
Tap the icon and put your finger on the waveform. The touched part of the waveform is
displayed in a magnifier. Drag your finger on the screen to move the magnifier. You can
change the zoom factor using the [Navigation] knob.
Search
Performs a search according to the settings in the "Search Setup" dialog box. Tap the
icon and then tap the diagram with the waveform to be searched, or drag a rectangle to
define a search gate. The search is performed on the selected waveform.
Operating the instrument
To Next Page
Loading...
