Rohde & Schwarz RTP044 - Page 860

Protocol analysis
R&S
®
RTP
860User Manual 1337.9952.02 ─ 12
13.20.5.2 USBPD search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog to better see the "Search Results" table.
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:USBPd:FCOunt? on page 2100
●
SEARch:RESult:USBPd:FRAMe<m>:DATA? on page 2101
●
SEARch:RESult:USBPd:FRAMe<m>:TYPE? on page 2105
●
SEARch:RESult:USBPd:FRAMe<m>:INFO? on page 2103
●
SEARch:RESult:USBPd:FRAMe<m>:STATe? on page 2104
●
SEARch:RESult:USBPd:FRAMe<m>:STARt? on page 2104
●
SEARch:RESult:USBPd:FRAMe<m>:STOP? on page 2105
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:TYPE? on page 2103
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:STATus? on page 2101
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:STARt? on page 2102
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:STOP? on page 2102
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:VAL? on page 2103
●
SEARch:RESult:USBPd:FRAMe<m>:FLD<n>:FVAL? on page 2101
13.20.5.3 Searching USBPD data
Prerequisite: A serial bus is configured for the USBPD signal to be decoded and ana-
lyzed.
To be able to search for a USBPD data, the "Show decode detail" field in the "Configu-
ration" tab of the protocol setup should be disabled. If "Show decode detail" is enabled,
the "Enable" search button is disabled.
The search for events is set up in the following way:
1. Press the [Protocol] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
3. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
USBPD (option R&S
RTP-K63)