2 Parameters
2.2 List of parameters
SINAMICS G120D
424 List Manual (LH14), 01/2016, A5E33842313
Index: [0] = ON/OFF1
[1] = OC / OFF2
[2] = OC / OFF3
[3] = Operation enable
[4] = Ramp-function generator enable
[5] = Continue ramp-function generator
[6] = Speed setpoint enable
[7] = Acknowledge fault
[8] = Jog bit 0
[9] = Jog bit 1
[10] = Master control by PLC
[11] = Direction reversal (setpoint)
[12] = Enable speed controller
[13] = Motorized potentiometer raise
[14] = Motorized potentiometer lower
[15] = CDS bit 0
Description: For the manual mode: Sets the signal source for the speed setpoint.
Description: Sets the unit for displaying and entering speeds.
Value: 1: Hz
2: rpm
Description: Displays the macro file saved in the appropriate directory on the memory card/device memory.
Dependency: Refer to: p0015
Note: For a value = 9999999, the following applies: The read operation is still running.
p8543 CI: Active speed setpoint in the BOP/IOP manual mode / N_act act OP
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: T Scaling: p2000 Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - 8541[0]
p8552 IOP speed unit / IOP speed unit
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
1 2 2
p8558 BI: Select IOP manual mode / Sel IOP man mode
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: U, T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - 0
r8570[0...39] Macro drive object / Macro DO
Access level: 1 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
To Next Page
Loading...
