Siemens SINAMICS G120D CU240D-2 DP - 3.6 Internal control;status words

3 Function diagrams
3.6 Internal control/status words
SINAMICS G120D
640 List Manual (LH14), 01/2016, A5E33842313
3.6 Internal control/status words
Function diagrams
2501 – Control word, sequence control (r0898) 641
2503 – Status word, sequence control (r0899) 642
2505 – Control word, setpoint channel (r1198) 643
2510 – Status word 1 (r0052) 644
2511 – Status word 2 (r0053) 645
2512 – Control word 1 (r0054) 646
2513 – Supplementary control word (r0055) 647
2520 – Control word, speed controller (r1406) 648
2522 – Status word, speed controller (r1407) 649
2526 – Status word, closed-loop control (r0056) 650
2530 – Status word, current control (r1408) 651
2534 – Status word, monitoring functions 1 (r2197) 652
2536 – Status word, monitoring functions 2 (r2198) 653
2537 – Status word, monitoring functions 3 (r2199) 654
2546 – Control word, faults/alarms (r2138) 655
2548 – Status word, faults/alarms 1 and 2 (r2139 and r2135) 656
2610 – Sequence control - Sequencer 657
2634 – Sequence control - missing enable signals, line contactor control 658