Siemens SINAMICS G120D CU240D-2 DP - 2.5 Parameters for write protection and know-how protection; 2.5.1 Parameters with WRITE_NO_LOCK; 2.5.2 Parameters with KHP_WRITE_NO_LOCK

SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
587
2 Parameters
2.5 Parameters for write protection and know-how protection
2.5 Parameters for write protection and know-how protection
2.5.1 Parameters with "WRITE_NO_LOCK"
The following list contains the parameters with the "WRITE_NO_LOCK" attribute.
These parameters are not affected by the write protection.
Product: SINAMICS G120D, Version: 4707900, Language: eng, Type: WRITE_NO_LOCK
p0003 Access level / Acc_level
p0010 Drive commissioning parameter filter / Drv comm. par_filt
p0124[0...n] CU detection via LED / CU detection LED
p0970 Reset drive parameters / Drive par reset
p0971 Save parameters / Save par
p0972 Drive unit reset / Drv_unit reset
p2111 Alarm counter / Alarm counter
p3950 Service parameter / Serv par
p3981 Faults acknowledge drive object / Faults ackn DO
p3985 Master control mode selection / PcCtrl mode select
p7761 Write protection / Write protection
p8805 Identification and maintenance 4 configuration / I&M 4 config
p8806[0...53] Identification and Maintenance 1 / I&M 1
p8807[0...15] Identification and Maintenance 2 / I&M 2
p8808[0...53] Identification and Maintenance 3 / I&M 3
p8809[0...53] Identification and Maintenance 4 / I&M 4
p9400 Safely remove memory card / Mem_card rem
p9484 BICO interconnections search signal source / BICO S_src srch
2.5.2 Parameters with "KHP_WRITE_NO_LOCK"
The following list contains the parameters with the "KHP_WRITE_NO_LOCK" attribute.
These parameters are not affected by the know-how protection.
Product: SINAMICS G120D, Version: 4707900, Language: eng, Type: KHP_WRITE_NO_LOCK
p0003 Access level / Acc_level
p0010 Drive commissioning parameter filter / Drv comm. par_filt
p0124[0...n] CU detection via LED / CU detection LED
p0970 Reset drive parameters / Drive par reset
p0971 Save parameters / Save par
p0972 Drive unit reset / Drv_unit reset
p2111 Alarm counter / Alarm counter
p3950 Service parameter / Serv par
p3981 Faults acknowledge drive object / Faults ackn DO
p3985 Master control mode selection / PcCtrl mode select
p7761 Write protection / Write protection
p8805 Identification and maintenance 4 configuration / I&M 4 config
p8806[0...53] Identification and Maintenance 1 / I&M 1
p8807[0...15] Identification and Maintenance 2 / I&M 2
p8808[0...53] Identification and Maintenance 3 / I&M 3
p8809[0...53] Identification and Maintenance 4 / I&M 4
p8980 Ethernet/IP profile / Eth/IP profile
p8981 Ethernet/IP ODVA STOP mode / Eth/IP ODVA STOP
p8982 Ethernet/IP ODVA speed scaling / Eth/IP ODVA n scal