Siemens SINAMICS G120D CU240D-2 DP - r61000[0...239] PROFINET Name of Station; PN Name of Station; r61001[0...3] PROFINET IP of Station; PN IP of Station

SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
561
2 Parameters
2.2 List of parameters
Note: The clearance to the PZD telegram can be increased using p2071.
After changing p0922/p2079 or p2071, then p60122 must be set again.
The telegram interconnections can only be changed if p60122 and p0922 are both set to 999.
Description: Displays PROFINET Name of Station.
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
Description: Displays PROFINET IP of Station.
r61000[0...239] PROFINET Name of Station / PN Name of Station
CU240D-2_PN
CU240D-2_PN_F
CU250D-2_PN_F
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 2410
Min Max Factory setting
- - -
r61001[0...3] PROFINET IP of Station / PN IP of Station
CU240D-2_PN
CU240D-2_PN_F
CU250D-2_PN_F
Access level: 3 Calculated: - Data type: Unsigned8
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: 2410
Min Max Factory setting
- - -