When executing a test run, follow the notice and procedures in this instruction
manual. Otherwise, it may cause a malfunction, damage to the machine, or injury.
Do not operate the switches with wet hands. Otherwise, it may cause an electric
shock.
Before starting operation, check the parameters. Improper settings may cause
some machines to operate unexpectedly.
The driver heat sink, regenerative resistor, servo motor, etc., may be hot while the
power is on and for some time after power-off. Take safety measures such as
providing covers to avoid accidentally touching them by hands and parts such as
cables.
During operation, never touch the rotor of the servo motor. Otherwise, it may
cause injury.
Before wiring, switch operation, etc., eliminate static electricity. Otherwise, it may
cause a malfunction.
To Next Page
Loading...
Need help?
General