Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If a fixed value is described for each digit of the parameter, never change the
value of that digit.
Do not change the parameters for manufacturer settings.
Do not set a value other than those described for each parameter.
To enable a parameter whose symbol is preceded by *, cycle the power after
setting it.
The symbols in the control mode column mean as follows.
CP: Positioning mode (point table method)
CL: Positioning mode (program method)
PS: Positioning mode (indexer method)
Setting a value out of the setting range in each parameter will trigger [AL. 37
Parameter error].
To Next Page
Loading...