SMC Networks LECSB2-T Series

16 - 314
16. POSITIONING MODE
16.27 COMMUNICATION FUNCTION (MITSUBISHI GENERAL-PURPOSE AC SERVO
PROTOCOL)
POINT
Creating and reading programs are not available with Mitsubishi general-
purpose AC servo protocol (RS-422 communication). Use Setup software (MR
Configurator2
TM
).
16.27.1 Reading command
POINT
Even if a command or data No. is the same between different model drivers, its
description may differ.
The symbols in the control mode column mean as follows.
CP: Positioning mode (point table method)
CL: Positioning mode (program method)
PS: Positioning mode (indexer method)