For the mark detection function (Current position latch), refer to section 12.2.1.
For the mark detection function (Interrupt positioning), refer to section 12.2.2.
For the infinite feed function (setting degree), refer to section 12.3.
There are the following restrictions on the number of gear teeth on machine side
([Pr. PA06 Number of gear teeth on machine side]) and the servo motor speed
(N).
When CMX ≤ 2000, N < 3076.7 r/min
When CMX > 2000, N < (3276.7 - CMX)/10 r/min
When the servo motor is operated at a servo motor speed higher than the limit
value, [AL. E3 Absolute position counter warning] will occur.
To Next Page
Loading...