ST STM32F207 series User Manual

Revision history RM0033
1358/1381 RM0033 Rev 9
15-Apr-2011
3
(continued)
SPI:
Added TI frame error detection in Slave transmitter only mode in
Section : SPI TI protocol in slave mode.
Modified CRC error in Section 25.3.10: Error flags.
Updated Section : DMA capability with CRC and Section 25.3.6:
CRC calculation.
Updated description of CRCNEXT in Section 25.5.1: SPI control
register 1 (SPI_CR1) (not used in I
2
S mode).
Added note related to I2S PLL used as I2S input clock in
Section 25.4.3: Clock generator.
SDIO:
Updated condition respected by PCLK2 and SDIO_CK in
Section 26.3: SDIO functional description.
ETHERNET:
Remove TX_ETR signal from Figure 317: Media independent
interface signals.
USB OTG FS:
Updated in B-device session request protocol sequence.
Added caution note related to minimum AHB frequency
in
Section 29.3.3: Full-speed OTG PHY.
Modified TIM2 enable bits in Section 29.7.1: Host SOFs and
Section 29.7.2: Peripheral SOFs.
Updated OTG_FS_CID reset value.
USB OTG HS:
Added Note 1 below Figure 373: USB OTG interface block diagram.
Updated in B-device session request protocol sequence.
Added caution note related to minimum AHB frequency
in
Section 30.3.2: High-speed OTG PHY. Updated FSLSPCS definition
in Section : OTG_HS host configuration register (OTG_HS_HCFG).
Modified TIM2 enable bits in Section 30.7.1: Host SOFs and
Section 30.7.2: Peripheral SOFs.
In Section : OTG_HS host channel-x interrupt register
(OTG_HS_HCINTx) (x = 0..11, where x = Channel_number)
changed bit 2 of OTG_HS_HCINTx registers to AHBERR.
Added NPTXFE bit description in Section : OTG_HS core interrupt
register (OTG_HS_GINTSTS).
Updated maximum values of RXFD and NPTXFD in Section :
OTG_HS Receive FIFO size register (OTG_HS_GRXFSIZ), and
maximum in Section : OTG_HS nonperiodic transmit FIFO
size/Endpoint 0 transmit FIFO size register
(OTG_HS_GNPTXFSIZ/OTG_HS_TX0FSIZ), respectively.
Modified NPTXFSAV description in Section : OTG_HS nonperiodic
transmit FIFO/queue status register (OTG_HS_GNPTXSTS).
Updated OTG_HS_CID register reset value.
Table 224. Document revision history (continued)
Date Version Changes

ST STM32F207 series Specifications

General

Brand	ST
Model	STM32F207 series
Category	Microcontrollers
Language	English