Terex MHL360 E - Page 259

CARE AND MAINTENANCE 7
MHL360 E 7.39
To refuel, proceed as follows:
►
Open the tank cover on the fuel tank (pres-
sure equalization!).
►
Remove the sealing cover (281/1) from the
intake adapter (281/2).
►
Mount the intake hose on the intake adapt-
er (281/2).
►
Introduce the free end of the intake hose
with the filter side into a fuel barrel.
►
Keep the toggle switch (281/3) next to the
refueling pump in the upper position, "ON",
to pump fuel into the tank of the machine.
The maximum fill level is achieved when
the LED (281/4) lights up red.
ATTENTION
Make certain the fuel level does not
fall below the intake level of the in-
take hose. The pump should not be
allowed to run dry under any cir-
cumstances.
►
Release the toggle switch (281/3) to the
lower "OFF" position. The refueling pump
stops.
►
Uncouple the intake hose and make sure
that there is no fuel in the intake hose be-
fore stowing it away. Seal the intake
adapter (281/2) with the cap (281/1).
ATTENTION
It is essential to use the cap, since
the built-in non-return valve is not
suitable for providing a long-term
seal.
►
Close the tank cover.
360-0860-032
2
4
1
3
Fig. 281 Tank filling pump