Topcon Pocket-3D - Page 311

Index
P/N 7010-0628
Index
as reference line 4-6
collect along polyline 4-8
create point 3-82
information 1-12
properties 3-14, 3-83, 3-86, 3-
88, 3-91, 4-3
Polyline
as reference line 4-6
collect points 4-8–4-9
stakeout 4-33
Polylines
information 1-12
linework files 3-60
measure 4-2, 4-59
Position
GPS 1-17
total station 1-21
R
Radio link, lost 1-11
Radio setup 2-6–2-7, 2-10
equipment 2-5
Range pole
setup 2-4, 2-30
total station setup 2-30
Receiver
mask angle 1-18
reset 1-18
Receiver ID, GPS 1-18
Reference line, measure 4-6
Resection 2-24
Reset receiver 1-18
Road surface 3-28–3-37
apply template 3-36
centerline 3-29
point of beginning 3-29
template definitions 3-32
vertical profile 3-31
viewing options 3-45
Rover setup 2-27
Roving point
measurement options 4-15
S
Sample Configuration 4
Total Station with Prism 2-31
Satellites, GPS 1-18
Save
compared surfaces 3-43, 3-98
points/polylines 1-12
units 2-11
Search, total station 1-21
Selection
polygon 1-12
window 1-12
Set Total Station Search Parameters 
1-21
Setup
antenna 2-7–2-8
base station 2-10, 2-23
equipment
GPS 2-2–2-5
mmGPS 2-17
radio 2-6–2-7
rover 2-27
sensor
range pole 2-28
station 2-36
transmitter 2-18–2-25
units 2-11
Show 5-4
Stakeout
alignment 4-28
control point 4-36
coordinate 4-34
custom point list 4-38
options 4-55
point list 4-26
polyline 4-33
station 4-28
Station setup 2-36
Surface
files 3-24
properties 3-93
volume 3-43
Surface check 4-22
Surfaces
best-fit 3-24, 3-39–3-41